Getting Started

Step 1

Step 1 Example

Step 2

Step 2 Example

Step 3

Step 4

Step 5

Step 6

Get your tools and plug, we use pruning shears, a box cutter, and a multi tool (needle nose pliers would work fine)

Using the shears cut 2 times on the inside of the plug. You cut on the side that doesnt have the opening for the wire.

Try to replicate the opposite sides spacing and length (these cuts are a little long but will work)

Grab the area in between your cuts and lift up, you can then cut this out or just twist and break the plastic.

You can go ahead and us the plug like this if you want, we usually will take the knife and clean up the edges.

CAREFULLY cut away the excess plastic to get a smooth edge. This step is optional if you have enough room for the wire.

You can now place the plug were you need it on the wire.

Slide on the back

Enjoy your custom Quick Connect Plug.