
![]() |
10 Track Universal Chaser Controller
|
| 10 Track Universal Lighting Controllers Examples |
| Chaser light controllers turn on one track at a time. A 10 Track Universal Chaser has 10 receptacles. Each receptacle represents one track. |
![]() |
| All chaser controllers have a speed control dial. |
| 10 Track Model set in 7 Track Chase Mode |
|
| ||
![]() | ||
Chase Mode turns on the receptacles in order.
|
| 10 Track Model set in 8 Track Chase Mode |
![]() |
||
|
| 10 Track Model set in 9 Track Chase Mode |
![]() |
||
|
| 10 Track Model Set in 10 Track Chase Mode |
![]() |
||
|
| 10 Track Model with a Delay Feature |
![]() | ||
| The Delay Feature holds a receptacle on for an adjustable period. The Example above shows a three step delay. The seventh receptacle is held on for three extra steps.
|
| 10 Track Model with a Blank Feature |
|
| ||
![]() | ||
| The Blank Feature turns off all the
receptacles for an adjustable period. The example above shows a three step blank
|
| 10 Track Universal Chaser Controller Settings Instructions 10 Track Model |
| The photograph on the right is a font view of the circuit board located inside the controller. Note: All settings should be applied with the controller unplugged. Remove screw and the front panel. The dip switch #1 and jumpers #2 are adjustable with needle nose pliers. The dip switch #1 has eight toggle switches. Gently depress the switch that corresponds with the diagram for your desired setting. The jumpers #2 are pulled up and off the posts and pressed into place with pliers. |
![]() |
![]() | Each receptacle in the photograph on the left represents one track. The chase pattern will turn on each track according to the settings. |
| 7 Track Chase Steps: 7 Pattern: 1, 2, 3, 4, 5, 6, 7 repeat |
![]() |
| 7 Track Chase with a 2 step delay on 7 Steps: 9 Pattern: 1, 2, 3, 4, 5, 6, 7, 7, 7 repeat |
![]() |
| 7 Track Chase with a 2 step delay on 7 and a 1 step delay on 1 Steps: 10 Pattern: 1, 1, 2, 3, 4, 5, 6, 7, 7, 7 repeat This setting requires a special order jumper wire. |
![]() |
| 8 Track Chase Steps:8 Pattern: 1, 2, 3, 4, 5, 6, 7, 8 repeat |
![]() |
| 8 Track Chase with a 2 step delay on 8
Steps:10 Pattern: 1, 2, 3, 4, 5, 6, 7, 8, 8, 8 repeat |
![]() |
| 8 Track Chase with a 1 step delay on 1 and 8. Steps:10 Pattern: 1, 1, 2, 3, 4, 5, 6, 7, 8, 8 repeat This setting requires a special order jumper wire. |
![]() |
| 9 Track Chase Steps:9 Pattern 1, 2, 3, 4, 5, 6, 7, 8, 9 repeat |
![]() |
| 9 Track Chase with a 1 step delay on 1 Steps:10 Pattern: 1, 3, 4, 5, 6, 7, 8, 9, 10 repeat Receptacle 2 is not used |
![]() |