P.O. Box 208 · 384 Broyles St. · Sparta · TN · 38583
Phone: 931-836-1212 · Fax: 931-836-2002
6 Track
Universal Chaser Controller
Model 6TU-18
 |
6 Track Universal Chaser Controller
|
| 6 Track Universal Chaser Lighting Controllers Examples |
| Chaser lighting controllers turn on one track at a time. A 6 Track Universal Chaser has 6 receptacles. Each receptacle represents one track. |
| All chaser controllers have a speed control dial. |
| 6 Track Model set in 5 Track Chase Mode |
|
 | |||
| 5 Track Chase Mode activates the receptacles in order. |
| 6 Track Model set in 6 Track Chase Mode |
|
 |
 | |||
| The receptacles are wired to each of the six deer. The controller activates the receptacles in order. | |||||
| 6 Track Model with a Delay Feature |
|
|
 | ||
| The example above shows a four step delay. The delay feature holds a receptacle on for an adjustable period. The first deer is held on for four steps. The rest of the deer are on for one step each. | ||||
| 6 Track Model with a Blank Feature |
 | ||||
|
| 6 Track Universal Chaser Controller Settings Instructions |
| Setting a New Chase
Pattern A 6TU-18 will arrive pre-set in 6 track chase. The photograph on the right is a front view of the circuit board located inside the controller. Note: All settings should be applied with the controller unplugged. Remove screw and the front panel. The dip switch and jumpers are adjustable with needle nose pliers. The dip switch has eight toggle switches. Gently depress the switch that corresponds with the diagram (below) for your desired setting. The jumpers are pulled up and off the posts and pressed into place with pliers. |
 |
 |
The controller will turn on the numbered receptacles according to the chase pattern you set. |
| 5 Track
Chase Steps: 5 Pattern: 1, 2, 3, 4, 5 repeat |
 |
| 5 Track
Chase with a 2 step delay on 5 Steps: 7 Pattern: 1, 2, 3, 4, 5, 5, 5 repeat |
 |
| 5 Track
Chase with a 2 step delay on 1 and 5 Steps: 9 Pattern: 1, 1, 1, 2, 3, 4, 5, 5, 5 repeat This setting requires a special order jumper wire. |
 |
| 6 Track
Chase Steps:6 Pattern: 1, 2, 3, 4, 5, 6 repeat |
 |
| 6 Track
Chase with a 2 step delay on 6 Steps:8 Pattern: 1, 2, 3, 4, 5, 6, 6, 6 repeat |
 |
| 6 Track
Chase with a 2 step delay on 1 and 6. Steps:10 Pattern: 1, 1, 1, 2, 3, 4, 5, 6, 6, 6 repeat This setting requires a special order jumper wire. |
 |
| Adding a blank ( all receptacles off ) First achieve a chase setting that you like. Then add blank steps by depressing the next dip switch down. To add a two step blank depress the 2nd to next dip switch down. All chaser controllers have a ten step maximum. |
| 5 Track
Chase with 3 step blank Steps: 8 Pattern: 1, 2, 3, 4, 5, off, off, off repeat |
 |
