$25 Minimum Online Order - $100 Minimum Phone Order

Get 10% off orders of $40 or more. Enter coupon code SAVE10 during checkout.
*Valid on online orders only. Order must meet $40 before shipping.

Rope Light

Rope Light Spools

If you are looking for a versatile lighting product for your home or business consider rope light. This easy to install lighting system works indoors and out and it's great for both temporary and permanent applications. We offer rope light in spools of 150', each spool includes all the necessary accessories to make multiple strings. In addition to spools we offer many accessories as well as controllers to make our 3 wire rope light chase.

These types of flexible neon lights are great for lighting roof lines as well as walk ways and paths, we have many customers use it as accent lighting above or below cabinets. As always, it's right at home lighting up the holidays. Below you'll find the 3/8" and 1/2" rope light size and wire count options. 2 wire incandescent rope light can only flash or fade, but 3 wire styles can chase and do other various animations. The LED options are great for permanent installations because of its long bulb life or for using much less power for your home decor.

Recommended For

  • Outling Walkways, Buildings, Docks & More.

  • Lighting Signs

  • Create Custom Displays

  • Accent Lighting

  • Shop for Rope Light

3/8 inch Rope Light  Spools

1/2 inch Rope Light  Spools

 3 Wire Rope Light  Spools

LED Rope Light  Spools

Rope Light Controllers

Do's and Don'ts
Must be cut straight at the appropriate scissor icon. Failure to do so will cause damage to circuit.

We recommend the plastic hose or conduit cutter, available through most hardware stores.

Maximum radius: 1 1/2" bend.

Please USE Tie Strap, Mounting Clips, U-Channel, Y Cable, Spider Cable, Filler Cable, or Suction Cups.

Note: The spears/pins on splice kits,power connectors, etc must be inserted into the center of the wires. Failure to do so will prevent light from working or cause product to short circuit.
Use hacksaws, carton cutters or common household scissors to cut rope.

Try to repair an uneven cut. Instead advance to the next scissor mark on the coil and cut again.

DO NOT make 90-degree turn

DO NOT fold back onto itself.

Please DO NOT USE masking tape, electrical tape, gluing, painting, Nailing, or stapling.

Note: Lights should not be fully recessed. If recessed too deep, it can cause string to overheat and fail.


How to Cut Rope Light

First turn the power off, then locate the cut marks printed on the rope at each end of the defective section. Use a straight edge cutting tool like PVC pipe cutters, or a single-blade pruning shear to cut at the cut marks. After that, remove the defective section.

Slide the heat shrink tubing over the new section and install the splice pins, then rejoin the new section with the splice pin.

Test to make sure all of the lights are working.

Center the heat shrink over the splice and use a heat gun or hair dryer to shrink the tubing into place. Be careful not to melt the rope light during this process but the heat shrink tubing does need to be very tight.